Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Sometimes it's fabric, sometimes it's varnish, sometimes it's paint and sometimes it's a combination of either/all of those things. Generally, the only...
-
I hope you guys work it out so that the prop goes to a collector and the hub goes either to a restoration project or to a collector. The collector wants...
Leave a comment:
-
It's practically impossible to identify it without the information that was stamped on the hub. There are just too many models with different shapes...
Leave a comment:
-
See this link. Bob Gardner is no longer able to post here, but he has written 10 excellent volumes about them and I take his advice very seriously.
Leave a comment:
-
It seems consistent with an OX5 hub but I think it's longer than a Jenny prop, at least compared to the ones that I've owned or seen. Unfortunately without...
Leave a comment:
-
It was manufactured for the Cessna AT17 Bobcat by a number of different manufacturers in large numbers. With the introduction of variable pitch propellers...
Leave a comment:
-
There are waaaay too many possibilites to identify it. All you have is a serial number and blade identifications (1 and 2). Many hundreds of models...
Leave a comment:
-
What width do you mean? The wooden hub width can vary. You're measuring the dimensions of the metal hub, which is standard for the engine used. The...
Leave a comment:
-
You're welcome. By the way if you're interested, you might be able to correlate it with a engine possibility by going to this page then carefully measuring...
Leave a comment:
-
The ends have almost certainly been cut off (not an uncommon situation when prop tips are damaged) and it is virtually impossible to identify it without...
Leave a comment:
-
Tony, Rhett is my friend that I mentioned to you and to whom I sent an email about your prop. He lives in Raleigh, NC and happens to be in England now...
Leave a comment:
-
-
It depends on how you figure it. See this link. As a collector I wouldn't pay that, but on eBay or some similar venue it might go for more than that....
Leave a comment:
-
The "SE" prefix part of the model number refers to "Steam Engineering", a branch of the U.S. Navy responsible for propeller development...
- 1 like
Leave a comment:
-
I think it's a Sensenich propeller. See photo below with stamped info.
You can go to this page, scroll down to find the design number, 86r61,...You do not have permission to view this gallery.
This gallery has 1 photos.
- 1 like
Leave a comment:
-
You might be better off selling it privately. Auctions typically have very high commissions and if there's only one low bid you're out of luck. Do you...
Leave a comment:
No activity results to display
Show More
Leave a comment: