Tweet
Hi, I have an 8 foot/244 cm propeller with the following markings:
D M B
NO (or ND) 858
WALTER NZ (an engine from the Walter Engine Company)
130 PS
D2 (possibly followed by a 5)
H1 (also possibly followed by a 5)
ZU
The blade i 20 cm wide, 14 cm deep and has brass leading edge sheathing held on by flush rivets.
It has 8, approximately 1 cm diameter, bolt holes at 13 cm centre to centre.
I would like to know who the manufacturer (DMB?) was. Any other information is, of course, welcome!
Thank you!
D M B
NO (or ND) 858
WALTER NZ (an engine from the Walter Engine Company)
130 PS
D2 (possibly followed by a 5)
H1 (also possibly followed by a 5)
ZU
The blade i 20 cm wide, 14 cm deep and has brass leading edge sheathing held on by flush rivets.
It has 8, approximately 1 cm diameter, bolt holes at 13 cm centre to centre.
I would like to know who the manufacturer (DMB?) was. Any other information is, of course, welcome!
Thank you!